Geeetech 3DTouch auto bed leveling sensor for 3D printer from Geeetech
Description of Geeetech 3DTouch auto bed leveling sensor for 3D printer...
We are proud to present the excellent Geeetech 3DTouch auto bed leveling sensor for 3D printer.
With so many available today, it is great to have a brand you can recognise. The Geeetech 3DTouch auto bed leveling sensor for 3D printer is certainly that and will be a superb acquisition.
For this great price, the Geeetech 3DTouch auto bed leveling sensor for 3D printer comes highly respected and is always a popular choice amongst lots of people. Geeetech have provided some great touches and this means great value.
Max. Current: 300mA
Cable length: 150mm
Net Weight: 10g
Shipping weight: 25g
3DTouch can be operated in the following condition.
One I/O for control (PWM or Software PWM)
One I/O for Z min (Z Probe)
GND and +5V power
3-pin: Brown (-, GND), Red (+5V), Orange (control signal)
2-pin: Black (-, GND), White (Z min)
Additional power supply will be needed in case your board does not supply enough amperage.
Electronic devices can be damaged or even destroyed if connected to wrong polarity.
[wrong terminal connect to 5V(+) and GND(-)]
Pulling/pushing hard on the push-pin can damage 3DTouch and make it less accurate.
Fix push-pin with locking paint after reassembling or adjusting core.
Do not remove or deform elastic material attached on the push-pin.
1 X 3DTouch Auto leveling sensor
1 X 3Pin Straight Pin
1 X 2Pin Straight Pin
2 X Screw & Nut & Washer
2 X Dupont Housing Shell 3Pin
2 X Dupont Housing Shell 2Pin
3 X Dupont Housing Shell 1Pin
14 X Dupont Terminal
1 X 10K¦¸ 1/8W Resistor